OIL COOLER INSTALLATION

PROCEDURE


  1. INSTALL TRANSMISSION OIL COOLER


    1. Install the transmission oil cooler to the front engine mounting bracket with the 2 bolts.

      Torque:
      13.5 N*m  { 138 kgf*cm, 10 ft.*lbf }

  2. CONNECT INLET NO. 1 OIL COOLER HOSE


    1. B006YJ5C01
      *a 0 to 3 mm (0 to 0.118 in.)
      *b 2 to 7 mm (0.0787 to 0.276 in.)
      *c Paint Mark

      Connect the inlet No. 1 oil cooler hose to the transmission oil cooler and slide the clip to secure it.

      Note


      • Make sure to slide the inlet No. 1 oil cooler hose until it contacts the hose stopper of the transmission oil cooler.

      • Make sure to align the paint mark of the inlet No. 1 oil cooler hose with the paint mark of the transmission oil cooler.

  3. CONNECT OUTLET NO. 1 OIL COOLER HOSE


    1. B006XBWC01
      *a 0 to 3 mm (0 to 0.118 in.)
      *b 2 to 7 mm (0.0787 to 0.276 in.)
      *c Paint Mark

      Connect the outlet No. 1 oil cooler hose to the transmission oil cooler and slide the clip to secure it.

      Note


      • Make sure to slide the outlet No. 1 oil cooler hose until it contacts the hose stopper of the transmission oil cooler.

      • Make sure to align the paint mark of the outlet No. 1 oil cooler hose with the paint mark of the transmission oil cooler.

  4. CONNECT NO. 3 WATER BY-PASS HOSE


    1. B006WZCC01
      *a 2 to 7 mm (0.0787 to 0.276 in.)
      *b Paint Mark
      *c 60° (Claw of Clip Location)

      Connect the No. 3 water by-pass hose to the transmission oil cooler and slide the clip to secure it.

      Note


      • Make sure to slide the No. 3 water by-pass hose until it contacts the hose stopper of the transmission oil cooler.

      • Make sure to align the paint mark of the No. 3 water by-pass hose with the paint mark of the transmission oil cooler.

      • Make sure that the claws of the clip are within the location shown in the illustration.

  5. CONNECT NO. 4 WATER BY-PASS HOSE


    1. B006Z07C01
      *a 2 to 7 mm (0.0787 to 0.276 in.)
      *b Paint Mark
      *c 60° (Claw of Clip Location)

      Connect the No. 4 water by-pass hose to the transmission oil cooler and slide the clip to secure it.

      Note


      • Make sure to slide the No. 4 water by-pass hose until it contacts the hose stopper of the transmission oil cooler.

      • Make sure to align the paint mark of the No. 4 water by-pass hose with the paint mark of the transmission oil cooler.

      • Make sure that the claws of the clip are within the location shown in the illustration.

  6. INSTALL AIR CLEANER ASSEMBLY

    Click here

  7. INSTALL INLET AIR CLEANER ASSEMBLY

    Click here

  8. INSTALL COOL AIR INTAKE DUCT SEAL

    Click here

  9. ADD ENGINE COOLANT

    Click here

  10. ADJUST AUTOMATIC TRANSAXLE FLUID

    Click here

  11. INSPECT FOR OIL LEAK

  12. INSPECT FOR COOLANT LEAK

    Click here