Click here

SPEED SENSOR REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission revolution sensor (NT) and transmission revolution sensor (NC) removal/installation are shown below.

Table 1. Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Transmission valve body assembly

  1. Reset memory

  2. Reset transaxle compensation code

  3. Perform road test to allow ECM to learn

  • Large shift shock

  • Deterioration of fuel efficiency

Click herefor UB80E Initialization

Click herefor UB80E Registration
Click here

PROCEDURE


  1. Click here

    REMOVE TRANSMISSION VALVE BODY ASSEMBLY

    Click here

  2. Click here

    REMOVE TRANSMISSION REVOLUTION SENSOR (NT)


    1. B0071TM

      Remove the bolt and transmission revolution sensor (NT) from the automatic transaxle case sub-assembly.

  3. Click here

    REMOVE TRANSMISSION REVOLUTION SENSOR (NC)


    1. B006Y63C01
      *1 Spacer

      Remove the bolt, spacer and transmission revolution sensor (NC) from the counter drive gear sub-assembly.