DIFFERENTIAL OIL SEAL REPLACEMENT

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front drive shaft oil seal LH and front drive shaft oil seal RH removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front wheel alignment adjustment Perform system variant learning and acceleration sensor zero point calibration.

  • VSC disabled or malfunctioning

  • DTCs are output

  • Slip indicator light illuminated

  • ABS warning light illuminated

Click here

PROCEDURE


  1. REMOVE FRONT DRIVE SHAFT ASSEMBLY

    Click here

  2. REMOVE DRIVE SHAFT BEARING BRACKET

    Click here

  3. REMOVE FRONT DRIVE SHAFT OIL SEAL LH


    1. B006Z3UN01

      Using SST, remove the front drive shaft oil seal LH from the automatic transaxle case sub-assembly.

      SST
      09308-00010

      Note

      Be careful not to damage the automatic transaxle case sub-assembly.

  4. REMOVE FRONT DRIVE SHAFT OIL SEAL RH


    1. B0071J7N01

      Using SST, remove the front drive shaft oil seal RH from the transaxle housing.

      SST
      09308-00010

      Note

      Be careful not to damage the transaxle housing.

  5. INSTALL FRONT DRIVE SHAFT OIL SEAL RH


    1. B0071F1C01
      *a Depth

      Using SST and a hammer, install a new front drive shaft oil seal RH to the transaxle housing.

      SST
      09316-60012   ( 09316-00011 )
      09950-70010   ( 09951-07150 )
      Standard Depth
      -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

      Note


      • Make sure that the front drive shaft oil seal RH is installed in the correct direction.

      • Do not damage the lip of the front drive shaft oil seal RH.

  6. INSTALL FRONT DRIVE SHAFT OIL SEAL LH


    1. B006ZRCC01
      *a Depth

      Using SST and a hammer, install a new front drive shaft oil seal LH to the automatic transaxle case sub-assembly.

      SST
      09649-17010
      09950-70010   ( 09951-07100 )
      Standard Depth
      -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

      Note


      • Make sure that the front drive shaft oil seal LH is installed in the correct direction.

      • Do not damage the lip of the front drive shaft oil seal LH.

  7. INSTALL DRIVE SHAFT BEARING BRACKET

    Click here

  8. INSTALL FRONT DRIVE SHAFT ASSEMBLY

    Click here