VALVE BODY ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission valve body assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Transmission valve body assembly

  • Solenoid (SL1, SL2, SL3, SL4, SL5 and/or SL6) valve

  1. Reset memory

  2. Reset transaxle compensation code

  3. Perform road test to allow ECM to learn

  • Large shift shock

  • Deterioration of fuel efficiency

Click here for Initialization

Click here for Registration

PROCEDURE


  1. REMOVE TRANSMISSION WIRE

    Click here

  2. REMOVE TRANSMISSION VALVE BODY ASSEMBLY


    1. B006Y36

      Disengage the clamp to disconnect the transmission revolution sensor (NC) wire connector.

    2. B004JVW

      Remove the 9 bolts and transmission valve body assembly from the automatic transaxle case sub-assembly.

    3. B006YNCC01
      *1 Transaxle Case Gasket
      *2 No. 1 Front Oil Pump Cover Gasket
      *3 No. 2 Front Oil Pump Cover Gasket

      Remove the 2 transaxle case gaskets from the automatic transaxle case sub-assembly.

    4. Remove the transaxle case gasket from the counter drive gear sub-assembly.

    5. Remove the No. 1 front oil pump cover gasket from the front oil pump assembly.

    6. Remove the No. 2 front oil pump cover gasket from the front oil pump assembly.