MILLIMETER WAVE RADAR SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Note

If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.

PROCEDURE


  1. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY


    1. B004NWPC02
      B006Z38 Bolt
      B006ZY0 Screw

      Engage the 2 guides.

    2. Tighten the 2 bolts and screw on the millimeter wave radar sensor assembly.

      Torque:
      Bolt
      2.5 N*m  { 25 kgf*cm, 22 in.*lbf }

      Tech Tips

      Tighten the bolts in the order shown in the illustration.

    3. Connect the connector.

  2. INSTALL COOL AIR INTAKE DUCT SEAL

    Click here

  3. ADJUST MILLIMETER WAVE RADAR SENSOR


    1. When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.

      Click here