MILLIMETER WAVE RADAR SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar sensor assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly

  • Dynamic radar cruise control system

  • Pre-collision system

  • Forward recognition camera system

  • Lane departure alert system (w/ Steering Control System)

Click here

PROCEDURE


  1. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  2. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY


    1. B004KKB

      Disconnect the connector.

    2. B004NWPC01
      B006Z38 Bolt
      B006ZY0 Screw

      Remove the 2 bolts and screw.

    3. Disengage the 2 guides to remove the millimeter wave radar sensor assembly.

      Note

      Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.