FORWARD RECOGNITION CAMERA SYSTEM TERMINALS OF ECU


  1. CHECK FORWARD RECOGNITION CAMERA

    Note


    • DTCs may be stored when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the GTS once the inspection has been completed.

    • Do not apply excessive force to the V6 forward recognition camera connector.

    B006X18E01

    1. Measure the voltage and resistance according to the value(s) in the table below.

      Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
      V6-7 (IGB) - V6-10 (GND) LA-P - LA Power source Ignition switch ON 11 to 14 V
      Ignition switch off Below 1 V
      V6-1 (HTR)*1 - V6-10 (GND) LA-B - LA Camera heater (forward recognition hood) operation signal

      Ignition switch ON

      Camera heater (forward recognition hood) not operating

      		 11 to 14 V

      Ignition switch ON

      Camera heater (forward recognition hood) operating

      		 Below 1 V
      V6-10 (GND) - Body ground LA - Body ground Ground Always Below 1 Ω

      *1: w/ Camera Heater

    2. Check for pulses according to the value(s) in the table below.

      Tech Tips

      If the waveform is not similar to that shown in the illustration, malfunction of a CAN bus line, terminating resistor or the forward recognition camera is suspected.

      Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
      V6-5 (CA1P) - V6-10 (GND) L - LA CAN communication signal Ignition switch ON

      Pulse generation

      (See waveform 1)
      V6-11 (CA1N) - V6-10 (GND) W - LA CAN communication signal Ignition switch ON

      Pulse generation

      (See waveform 2)
      V6-6 (CANH) - V6-10 (GND) G - LA CAN communication signal Ignition switch ON

      Pulse generation

      (See waveform 1)
      V6-12 (CANL) - V6-10 (GND) W - LA CAN communication signal Ignition switch ON

      Pulse generation

      (See waveform 2)

      1. B006Z0WE97
        *a 1 V/DIV.
        *b 10 μsec./DIV.

        Waveform 1

        Item Content
        Terminal Name

        Between V6-5 (CA1P) and V6-10 (GND)

        Between V6-6 (CANH) and V6-10 (GND)
        Tester Range 1 V/DIV., 10 μsec./DIV.
        Condition Ignition switch ON

        Tech Tips

        The waveform varies depending on the CAN communication signal.

      2. B006XCME89
        *a 1 V/DIV.
        *b 10 μsec./DIV.

        Waveform 2

        Item Content
        Terminal Name

        Between V6-11 (CA1N) and V6-10 (GND)

        Between V6-12 (CANL) and V6-10 (GND)
        Tester Range 1 V/DIV., 10 μsec./DIV.
        Condition Ignition switch ON

        Tech Tips

        The waveform varies depending on the CAN communication signal.