SHIFT LEVER REMOVAL

PROCEDURE


  1. SECURE VEHICLE


    1. Fully apply the parking brake and chock a wheel.

      CAUTION:


      • Make sure to apply the parking brake and chock a wheel before performing this procedure.

      • If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

      B006YU9

  2. REMOVE SHIFT LOCK RELEASE BUTTON COVER


    1. B004JGXC01
      *a Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and guide to remove the shift lock release button cover from the rear upper console panel sub-assembly.

      Note

      Be careful not to damage the shift lock release button cover and rear upper console panel sub-assembly.

  3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

    Click here

  4. REMOVE CONSOLE BOX ASSEMBLY

    Click here

  5. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

    Note

    Before disconnecting the transmission control cable assembly, check that the shift lever is in N.


    1. B004I8W

      Disconnect the transmission control cable assembly from the transmission floor shift assembly.

    2. B004J49C01
      *a Counterclockwise

      Rotate the lock nut counterclockwise approximately 180° and, while holding the lock nut in that position, disconnect the transmission control cable assembly from the transmission floor shift assembly.

  6. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY

    B007067

    1. Remove the 4 bolts.

    2. B004KBZ

      Remove the clip from the No. 1 console box duct.

    3. B004HWB

      Disconnect the transmission control switch connector.

    4. Disengage the clamp to disconnect the wire harness from the transmission floor shift assembly.

    5. B004L2O

      Disconnect the shift lock control ECU connector.

    6. Disengage the clamp to disconnect the wire harness from the transmission floor shift assembly.

    7. Remove the transmission floor shift assembly.