OIL PUMP REASSEMBLY

PROCEDURE


  1. INSTALL RING PIN


    1. B004OB5

      Install the 2 ring pins to the front oil pump cover sub-assembly.

  2. INSTALL FRONT OIL PUMP BODY


    1. B004M1H

      Install the front oil pump body to the front oil pump cover sub-assembly.

  3. INSTALL FRONT OIL PUMP DRIVEN GEAR


    1. B004JC7

      Coat the front oil pump driven gear with Toyota Genuine ATF WS and install it to the front oil pump body.

  4. INSTALL FRONT OIL PUMP DRIVE GEAR

    B004L0G

    1. Coat the front oil pump drive gear with Toyota Genuine ATF WS and install it to the front oil pump body.

  5. INSTALL STATOR SHAFT ASSEMBLY


    1. B004NGXN01

      Install the stator shaft assembly to the front oil pump body with the 5 bolts.

      Torque:
      9.1 N*m  { 93 kgf*cm, 81 in.*lbf }
      Bolt Length
      Bolt (A) Bolt (B)
      50 mm (1.97 in.) 45 mm (1.77 in.)

  6. INSTALL OIL STRAINER ASSEMBLY


    1. B004J1D

      Using a T30 "TORX" socket wrench, install a new oil strainer assembly to the front oil pump cover sub-assembly with the 2 "TORX" bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  7. INSTALL CLUTCH DRUM OIL SEAL RING


    1. Apply a small amount of MP grease to the entire circumference of the clutch drum oil seal ring installation groove portion.

      Tech Tips

      By applying MP grease, the wobble within the clutch drum oil seal ring installation groove will be eliminated, preventing damage to the clutch drum oil seal ring at the time of front oil pump assembly installation.

    2. B004NMM

      Coat 4 new clutch drum oil seal rings with Toyota Genuine ATF WS and install them to the stator shaft assembly.

      Note

      While making the spread of the opening of the clutch drum oil seal ring as small as possible, install it to the stator shaft assembly.

      If the ring opening is spread, briefly hold it closed with your fingers to return it to its original condition.