FRONT BUMPER INSTALLATION

PROCEDURE


  1. INSTALL FRONT BUMPER ASSEMBLY


    1. B004F5Y

      Connect the washer hose to drain the washer fluid.

    2. B004FH8

      Engage the 8 guides as shown in the illustration.

    3. Pull back the side of the front bumper assembly and connect the 3 connectors.

      Note

      Do not apply excessive force when pulling back the front bumper assembly.

    4. w/ Fog Light:


      1. Pull back the side of the front bumper assembly and connect the 2 fog light connectors.

        Note

        Do not apply excessive force when pulling back the front bumper assembly.

    5. B004GHC

      Engage the 3 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    6. Install the 2 clips.

    7. Install the 3 bolts.

    8. Install the 8 screws.

    9. Install the screw.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    10. B004EBJC01
      *1 Pin Hold Clip
      *a Correct
      *b Incorrect

      Install the pin hold clip as shown in the illustration.

      Note

      Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    11. Install the front bumper assembly with the clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

  2. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

  4. INSTALL COOL AIR INTAKE DUCT SEAL


    1. Install the cool air intake duct seal with the 8 clips.

  5. INSTALL ENGINE ROOM SIDE COVER


    1. Install the engine room side cover with the 4 clips.

  6. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  7. ADJUST FOG LIGHT ASSEMBLY (w/ Fog Light)

    Click here

  8. ADD WINDSHIELD WASHER FLUID

    Click here