HEADLIGHT ASSEMBLY(for Triple Beam Headlight) INSPECTION

PROCEDURE

1. INSPECT HEADLIGHT UNIT ASSEMBLY LH

   
   

   1. Remove the headlight assembly LH.

      Click here

   2. Remove the headlight unit LH from the headlight assembly LH.

      Click here

   3. Measure the resistance according to the value(s) in the table below.

      

      *a

      Component without harness connected (Headlight Unit Assembly LH)

      -

      -

      Standard Resistance
      Tester Connection Condition Specified Condition A-1 - E-8 Always Below 1 Ω A-2 - B-1 Always Below 1 Ω B-2 - C-1 Always Below 1 Ω C-2 - E-7 Always Below 1 Ω D-1 - F-4 Always Below 1 Ω D-2 - F-3 Always Below 1 Ω G-1 - F-14 Always Below 1 Ω G-2 - F-15 Always Below 1 Ω G-3 - F-6 Always Below 1 Ω LVL-1 - F-17 Always Below 1 Ω LVL-2 - F-8 Always Below 1 Ω LVL-3 - F-20 Always Below 1 Ω

      If the result is not as specified, replace the headlight unit assembly LH.

2. INSPECT HEADLIGHT UNIT ASSEMBLY RH

   
   

   1. Remove the headlight assembly RH.

      Click here

   2. Remove the headlight unit RH from the headlight assembly RH.

      Click here

   3. Measure the resistance according to the value(s) in the table below.

      

      *a

      Component without harness connected (Headlight Unit Assembly RH)

      -

      -

      Standard Resistance
      Tester Connection Condition Specified Condition A-1 - E-8 Always Below 1 Ω A-2 - B-1 Always Below 1 Ω B-2 - C-1 Always Below 1 Ω C-2 - E-7 Always Below 1 Ω D-1 - F-4 Always Below 1 Ω D-2 - F-3 Always Below 1 Ω G-1 - F-14 Always Below 1 Ω G-2 - F-15 Always Below 1 Ω G-3 - F-6 Always Below 1 Ω LVL-1 - F-17 Always Below 1 Ω LVL-2 - F-8 Always Below 1 Ω LVL-3 - F-20 Always Below 1 Ω

      If the result is not as specified, replace the headlight unit assembly RH.