DATA LIST
Note
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Tech Tips
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / (desired system) / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Parking Brake SW | Parking brake switch signal | ON or OFF | ON: Parking brake switch on OFF: Parking brake switch off |
- |
| Dimmer SW | Dimmer switch high position signal | ON or OFF | ON: Dimmer switch in high or high flash position OFF: Dimmer switch in low position |
- |
| Passing Light SW | Dimmer switch high flash position (pass) signal | ON or OFF | ON: Dimmer switch in high flash position OFF: Dimmer switch not in high flash position |
- |
| Rear Fog Light SW | Fog light switch rear position signal | ON or OFF | ON: Fog light switch in rear position OFF: Fog light switch off |
- |
| Front Fog Light SW | Fog light switch front position signal | ON or OFF | ON: Fog light switch in front position OFF: Fog light switch off |
*1 |
| Auto Light SW | Light control switch AUTO position signal | ON or OFF | ON: Light control switch in AUTO position OFF: Light control switch not in AUTO position |
- |
| Head Light SW (Head) | Light control switch head position signal | ON or OFF | ON: Light control switch in head position OFF: Light control switch not in head position |
- |
| Head Light SW (Tail) | Light control switch tail position signal | ON or OFF | ON: Light control switch in tail or head position OFF: Light control switch not in tail or head position |
- |
| Light Sensor Illuminance | Light control sensor illuminance | 0 to 8191 lx | Value is output according to ambient light level | - |
| Mirr-Foot-Lgt Approached/Exterior Light Approached | Outside handle foot light controlled by actuation area-linked function | ON or OFF | Customize setting displayed | - |
| Mirr-Foot-Lgt Unlocked/Exterior Light Unlocked | Outside handle foot light controlled by door unlock-linked function | ON or OFF | Customize setting displayed | - |
| Exterior Light (Door Open) | Door open control function of the outside handle foot light control | ON or OFF | Customize setting displayed | - |
| Mirror Foot Light Time/Exterior Light Time | Outside handle foot light lighting time | 7.5 s, 15 s, 30 s or 0 s | Customize setting displayed | - |
| Exterior Light Control | Setting of the outside handle foot light control on/off | ON or OFF | Customize setting displayed | - |
| Headlight Lighting Function | ECU which controls the lighting system | Main Body or Lighting Sys ECU | Customize setting displayed | - |
| Sensitivity | Sensitivity of the automatic light control system | Light2, Light1, Normal, Dark1 or Dark2 | Customize setting displayed | - |
| DRL Function | Setting of the DRL function on/off | ON or OFF | Customize setting displayed | - |
| Disp Ex ON Sen | Ambient brightness level required to dim display lights (combination meter, navigation display, etc.) | Light2, Light1, Normal, Dark1 or Dark2 | Customize setting displayed | - |
| Disp Ex OFF Sen | Ambient brightness level required to cancel dimming display lights (combination meter, navigation display, etc.) | Light2, Light1, Normal, Dark1 or Dark2 | Customize setting displayed | - |
| Light Auto OFF Delay | Light auto OFF delay | Off, 30 s, 60 s, or 90 s | Customize setting displayed | - |
| 2 Steps Fade Out Control Function | Setting of the 2 steps fade out control function on/off | ON or OFF | Customize setting displayed | - |
| Follow Me Home Lighting Time | Follow me home lighting time | 30 s, 60 s, 90 s or 120 s | Customize setting displayed | *2 |
| Light up Clearance Lights at Door Unlock Function | Setting of the light up clearance lights at door unlock function on/off | ON or OFF | Customize setting displayed | - |
| The Number of DTC | Number of trouble codes | 0 to 255 | Number of stored DTCs displayed | - |
*1: w/ Front Fog Light
*2: w/ Follow Me Home System
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Turn Signal Switch (Right) | Turn signal switch (right) signal | ON or OFF | ON: Turn signal switch (right) on OFF: Turn signal switch (right) off |
- |
| Turn Signal Switch (Left) | Turn signal switch (left) signal | ON or OFF | ON: Turn signal switch (left) on OFF: Turn signal switch (left) off |
- |
| Hazard Flasher Switch | Hazard warning signal switch signal | ON or OFF | ON: Hazard warning signal switch on OFF: Hazard warning signal switch off |
- |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Headlight Low Beam State | Low beam headlight state | ON or OFF | ON: Low beam headlights on OFF: Low beam headlights off |
- |
| Headlight High Beam State | High beam headlight state | ON or OFF | ON: High beam headlights on OFF: High beam headlights off |
- |
| DRL Operating State | Daytime running light state | ON or OFF | ON: Daytime running lights on OFF: Daytime running lights off |
- |
| Clearance Light State | Clearance light state | ON or OFF | ON: Clearance lights on OFF: Clearance lights off |
- |
| Right Cornering Light State | Cornering light RH state | ON or OFF | ON: Cornering light RH on OFF: Cornering light RH off |
* |
| Left Cornering Light State | Cornering light LH state | ON or OFF | ON: Cornering light LH on OFF: Cornering light LH off |
* |
| +B Voltage Value | Headlight ECU sub-assembly IG power supply voltage value | 0 to 19.75 V | 11.00 to 14.00 V | - |
| Number Of Trouble Codes | Number of trouble codes | 0 to 255 | Number of stored DTCs displayed | - |
*: Although the item is displayed on the GTS, it is not applicable to the vehicle.
ACTIVE TEST
Tech Tips
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / (desired system) / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Daytime Running Light | Daytime running lights | ON or OFF | - |
| Exterior Light | Outside handle foot lights | ON or OFF | - |
| Taillight Relay | Taillight relay | ON or OFF | - |
| Headlight Relay | Low beam headlights | ON or OFF | - |
| Head Light Hi | High beam headlights | ON or OFF | - |
| Front Fog Light Relay | Front fog lights | ON or OFF | Light control switch in tail position* |
| Rear Fog Light Relay | Rear fog lights | ON or OFF | Light control switch in tail position |
*: w/ Front Fog Light
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Clearance Light | Clearance lights | ON or OFF | - |
| Headlight Low Beam | Low beam headlights | ON or OFF | - |
| Headlight High Beam | High beam headlights | ON or OFF | - |
| Daytime Running Light | Daytime running lights | ON or OFF | - |
| Cornering Light | Cornering lights | ON or OFF | * |
*: Although the item is displayed on the GTS, it is not applicable to the vehicle.