RELAY ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT WIPER RELAY


    1. A01ODPSC05
      *a

      Component without harness connected

      (WIPER Relay)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 4 Auxiliary battery voltage not applied between terminals 1 and 2 Below 1 Ω
      Auxiliary battery voltage applied between terminals 1 and 2 10 kΩ or higher
      3 - 5 Auxiliary battery voltage not applied between terminals 1 and 2 10 kΩ or higher
      Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the WIPER relay.

  2. INSPECT INT RELAY


    1. A01ODPSC05
      *a

      Component without harness connected

      (INT Relay)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 4 Auxiliary battery voltage not applied between terminals 1 and 2 Below 1 Ω
      Auxiliary battery voltage applied between terminals 1 and 2 10 kΩ or higher
      3 - 5 Auxiliary battery voltage not applied between terminals 1 and 2 10 kΩ or higher
      Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the INT relay.