BLIND SPOT MONITOR MAIN SWITCH INSPECTION

PROCEDURE

1. INSPECT BLIND SPOT MONITOR MAIN SWITCH (WARNING CANCELING SWITCH ASSEMBLY)

   
   
   1. 

      *a	Component without harness connected (Blind Spot Monitor Main Switch (Warning Canceling Switch Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition 8 (B) - 11 (D) Blind spot monitor main switch on (not protruding) Below 25 Ω 8 (B) - 11 (D) Blind spot monitor main switch off (protruding) 1 MΩ or higher

      If the result is not as specified, replace the blind spot monitor main switch (warning canceling switch assembly).

   2. Check that the blind spot monitor indicator illuminates.

      
      
      1. 

         *a	Component without harness connected (Blind Spot Monitor Main Switch (Warning Canceling Switch Assembly))

         Apply auxiliay battery voltage to the blind spot monitor main switch (warning canceling switch assembly) and check that the switch illuminates.

         OK
         Connection Specified Condition Auxiliay battery positive (+) → Terminal 8 (B) Auxiliay battery negative (-) → Terminal 12 (E) Illuminates

         If the result is not as specified, replace the blind spot monitor main switch (warning canceling switch assembly).

   3. Check that the switch illuminates.

      
      
      1. 

         *a	Component without harness connected (Blind Spot Monitor Main Switch (Warning Canceling Switch Assembly))

         Apply auxiliary battery voltage to the blind spot monitor main switch (warning canceling switch assembly) and check that the switch illuminates.

         OK
         Connection Specified Condition Auxiliary battery positive (+) → Terminal 10 (ILL+) Auxiliary battery negative (-) → Terminal 9 (ILL-) Illuminates

         If the result is not as specified, replace the blind spot monitor main switch (warning canceling switch assembly).