NAVIGATION SYSTEM Navigation Receiver Assembly Power Source Circuit

DESCRIPTION

This is the power source circuit to operate the radio receiver assembly.

WIRING DIAGRAM

A01WXCUE10

CAUTION / NOTICE / HINT

Note

Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY POWER SOURCE)


    1. Disconnect the O57 radio receiver assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      O57-12 (GND1) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      O57-17 (+B1) - O57-12 (GND1) Power switch off 11 to 14 V
      O57-16 (ACC1) - O57-12 (GND1) Power switch on (ACC) 11 to 14 V
      O57-15 (IG) - O57-12 (GND1) Power switch on (IG) 11 to 14 V
      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR