AUDIO AND VISUAL SYSTEM(for 10.3 Inch Display) Remote Touch Screen Does not Generate Vibration Feedback

DESCRIPTION

When each button displayed on the multi-display assembly is selected via remote touch screen operation, the remote touch (remote operation controller assembly) generates vibration feedback according to communication between the remote touch (remote operation controller assembly) and radio receiver assembly.

CAUTION / NOTICE / HINT

Note


  • Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

    Click here

  • When replacing the radio receiver assembly or navigation ECU, always replace it with a new one. If a radio receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:


    • A communication malfunction DTC may be stored.

    • The radio receiver assembly or navigation ECU may not operate normally.

PROCEDURE


  1. CHECK MULTI-DISPLAY ASSEMBLY CUSTOMIZE SETTING


    1. Check that the remote touch screen vibration feedback force customize setting is not set to "Off" on the multi-display assembly screen.

      OK
      The remote touch screen vibration feedback force customize setting is not set to "Off".
      Result
      Proceed to
      OK
      NG

    NG

    CHANGE CUSTOMIZE SETTING

    OK

  2. REMOTE TOUCH (REMOTE OPERATION CONTROLLER ASSEMBLY) SELF CHECK (CHECK VIBRATION FEEDBACK GENERATION CONDITION)


    1. Enter self-diagnostic mode.

      Click here

    2. Operate the remote touch screen laterally and check that the remote touch screen generates vibration feedback.

      Note

      Since the remote touch screen may recognize a pinch in/out or flick operation if operated with 2 fingers, always use 1 finger to operate the remote touch screen in self-diagnostic mode.

      OK
      Remote touch screen generates vibration feedback.
      Result
      Proceed to
      OK
      NG

    NG

    REPLACE REMOTE TOUCH (REMOTE OPERATION CONTROLLER ASSEMBLY) Click here

    OK

  3. CHECK NAVIGATION ECU


    1. Replace the navigation ECU with a new one.

      Click here

    2. Check the malfunction disappears.

      OK
      Malfunction disappears.
      Result
      Proceed to
      OK
      NG

    OK

    END (NAVIGATION ECU IS DEFECTIVE)

    NG

    REPLACE RADIO RECEIVER ASSEMBLY Click here