AUDIO AND VISUAL SYSTEM(for 10.3 Inch Display) Start Up Signal Circuit between Radio Receiver Assembly and Navigation ECU

DESCRIPTION

This circuit includes the navigation ECU and radio receiver assembly.

WIRING DIAGRAM

B004F2IE11
*1 Navigation ECU
*2 Radio Receiver Assembly

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NAVIGATION ECU)


    1. Disconnect the O148 radio receiver assembly connector.

    2. Disconnect the O150 navigation ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      O148-7 (SUP) - O150-21 (SUP) Always Below 1 Ω
      O148-7 (SUP) or O150-21 (SUP) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR