HEATED STEERING WHEEL CONTROLLER(w/ Lane Departure Alert System) REMOVAL

PROCEDURE


  1. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  2. REMOVE CRUISE CONTROL MAIN SWITCH

    Click here

  3. REMOVE STEERING PAD SWITCH ASSEMBLY

    Click here

  4. REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

    Click here

  5. REMOVE STEERING VIBRATION AND HEATER ECU


    1. B004FLW

      Disengage the guide to remove the wire harness from the lower steering wheel cover.

    2. Disconnect the 2 connectors.

    3. B004GP0C02
      *1 Heater Thermistor

      Remove the screw.

    4. Disengage the 2 claws of the lower steering wheel boss cover.

      Note

      If the heater thermistor comes off the lower steering wheel cover, replace the steering wheel assembly.

      Tech Tips

      Do not remove the lower steering wheel boss cover from the steering wheel sub-assembly. Loosen the lower steering boss cover.

    5. B004EZ8C01
      B004E6E Remove in this Direction

      Remove the 2 screws.

    6. Move the steering vibration and heater ECU until it reaches a position where the connector can be disconnected.

    7. Disconnect the connector to remove the steering vibration and heater ECU from the lower steering wheel cover.