BRAKE MASTER CYLINDER(for LHD) DISASSEMBLY

PROCEDURE


  1. REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS


    1. A01OBW3

      Loosen the clevis lock nut and remove the brake master cylinder push rod clevis and clevis lock nut from the brake master cylinder sub-assembly.

  2. REMOVE BRAKE MASTER CYLINDER RING PIN


    1. Mount the brake master cylinder sub-assembly in a vise.

      Note

      Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly.

    2. A01OAVE

      Using a 5 mm pin punch and a hammer, tap out the brake master cylinder ring pin from the brake master cylinder sub-assembly.

      Note

      Do not drop the brake master cylinder reservoir assembly.

  3. REMOVE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY


    1. Remove the brake master cylinder reservoir assembly from the brake master cylinder assembly.

    2. Remove the brake master cylinder assembly from the vise.

  4. REMOVE MASTER CYLINDER RESERVOIR GROMMET


    1. A01OBII

      Remove the 2 master cylinder reservoir grommets from the brake master cylinder assembly.

  5. REMOVE BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY

  6. REMOVE BRAKE FLUID INFORMATION LABEL

  7. REMOVE BRAKE MASTER CYLINDER RESERVOIR STRAINER