TIRE PRESSURE WARNING INITIATOR(for Rear Side) INSTALLATION

PROCEDURE


  1. INSTALL REAR TIRE PRESSURE MONITOR INITIATOR


    1. A01OD5IC01
      *a Grommet

      Install the rear tire pressure monitor initiator with the 2 nuts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

    2. Engage the grommet.

    3. Install the rear wheel house liner LH to its original position.

    4. A01OADM

      Connect the connector.

  2. INSTALL JACK ASSEMBLY

  3. INSTALL TIRE REPAIR SEAL

    Click here

  4. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

  5. INSTALL REAR WHEEL LH

    Click here

  6. INSPECT TIRE PRESSURE WARNING SYSTEM

    Click here