REAR DIFFERENTIAL CARRIER ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

    Note


    • Do not damage the installation surface when installing the rear differential carrier assembly.

    • The remaining oil may leak out when installing the rear differential carrier assembly.

    • Securely support the rear differential carrier assembly while performing this step to avoid excessively tilting or dropping the rear differential carrier assembly.

    • Install the bolts with the rear differential carrier assembly secured.


    1. B004E8HC01
      *a Torque Wrench Fulcrum Length

      Support the rear differential carrier assembly with a transmission jack.

      CAUTION:

      The rear differential carrier assembly is a heavy component. Make sure that it is supported securely.

    2. Install the 2 rear upper differential mount stoppers to the rear differential carrier assembly.

    3. Temporarily install the rear differential carrier assembly to the rear suspension member sub-assembly with the 2 rear lower differential mount stoppers and 2 new bolts (A).

    4. Using SST and a 12 mm hexagon wrench, temporarily install the rear differential carrier assembly and rear differential dynamic damper to the rear suspension member sub-assembly with 3 new bolts (B) and (C).

      SST
      09961-00950

      Tech Tips


      • Before installing the bolts (B) and (C), make sure that there is no clearance between the rear differential carrier assembly and rear differential mount cushion.

      • Install the 2 bolts (B) first.

    5. Using SST and a 12 mm hexagon wrench, tighten the 3 bolts (B) and (C).

      SST
      09961-00950
      Torque:
      Specified tightening torque
      103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

      Note

      Do not tilt the sleeve or deform the rubber of the mount when tightening the bolts (B) and (C).

      Tech Tips


      • Tighten the 2 bolts (B) first.

      • This torque value is effective when SST is parallel to the torque wrench.

      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 150 mm (5.91 in.)) + torque wrench (fulcrum length of 400 mm (1.31 ft.)):

        75 N*m (765 kgf*cm, 55 ft.*lbf)

    6. Tighten the 2 bolts (A).

      Torque:
      Bolt Type A
      95.1 N*m  { 970 kgf*cm, 70 ft.*lbf }
      Bolt Type B
      88.9 N*m  { 907 kgf*cm, 66 ft.*lbf }

  2. INSTALL TAIL EXHAUST PIPE LH

    Click here

  3. INSTALL TAIL EXHAUST PIPE ASSEMBLY

    Click here

  4. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

    Click here

  5. INSTALL REAR DRIVE SHAFT ASSEMBLY


    1. Install the rear drive shaft assembly LH and rear drive shaft assembly RH.

      Click here

  6. ADD DIFFERENTIAL OIL

    Click here

  7. INSPECT FOR DIFFERENTIAL OIL LEAK