FRONT AXLE HUB INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY


    1. Install the front axle hub sub-assembly to the steering knuckle with the 4 bolts.

      Torque:
      68.6 N*m  { 700 kgf*cm, 51 ft.*lbf }

  2. INSPECT FRONT AXLE HUB BEARING LOOSENESS

    Click here

  3. INSPECT FRONT AXLE HUB RUNOUT

    Click here

  4. INSTALL FRONT DISC

    Click here

  5. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

    Click here

  6. CONNECT FRONT SKID CONTROL SENSOR WIRE


    1. Connect the front skid control sensor wire connector to the front axle hub sub-assembly.

      Note

      Do not twist the front skid control sensor wire when installing it.

  7. INSTALL FRONT WHEEL

    Click here

  8. INSTALL ABS MOTOR RELAY


    1. With the power switch off, install the 2 ABS motor relays (ABS motor No. 1 relay and ABS motor No. 2 relay).

    2. Clear the DTCs.

      Click here

  9. CHECK FOR SPEED SENSOR SIGNAL

    Click here