FRONT AXLE HUB REMOVAL

CAUTION / NOTICE / HINT

Note

When removing or installing the front disc brake caliper assembly, pushing back the disc brake piston may cause a large clearance between the brake pads and brake disc. When the brake pedal is depressed with a large clearance between the brake pads and the brake disc, DTCs C1341, C1342, C1343 and/or C1344 related to abnormal brake fluid pressure may be stored. Make sure to clear the DTCs after performing this step.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE ABS MOTOR RELAY

    for LHD: Click here

    for RHD: Click here

  2. REMOVE FRONT WHEEL

    Click here

  3. DISCONNECT FRONT SKID CONTROL SENSOR WIRE


    1. A01O9MX

      Disconnect the front skid control sensor wire connector from the front axle hub sub-assembly.

  4. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY

    Click here

  5. REMOVE FRONT DISC

    Click here

  6. REMOVE FRONT AXLE HUB SUB-ASSEMBLY


    1. A01OAE9

      Remove the 4 bolts and front axle hub sub-assembly from the steering knuckle.