DYNAMIC RADAR CRUISE CONTROL SYSTEM, Diagnostic DTC:C1A52

DTC Code DTC Name
C1A52 Driving Support ECU Communication Abnormal

DESCRIPTION

The DTC C1A52 is stored when the hybrid vehicle control ECU assembly cannot recognize the driving support ECU assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A52 Driving Support ECU Communication Abnormal Approximately 17 seconds after the power switch is turned on (IG), the hybrid vehicle control ECU assembly cannot recognize the driving support ECU assembly for approximately 1.3 seconds or more.

  • Hybrid vehicle control ECU assembly

  • Driving support ECU assembly

CAUTION / NOTICE / HINT

Note


  • When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.

  • First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting.

    Click here

PROCEDURE


  1. CHECK FOR DTCs


    1. Clear the DTCs.


      Powertrain > Radar Cruise > Clear DTCs

    2. Perform the following to make sure that the DTC detection conditions are met.

      Tech Tips

      If the following conditions are not met, the system cannot detect the malfunction.


      1. Turn the power switch on (IG).

      2. Wait for 20 seconds or more.

    3. Check for DTCs.


      Powertrain > Radar Cruise > Trouble Codes
      Result
      Result Proceed to
      DTC C1A52 is not output A
      DTC C1A52 is output B

    A

    USE SIMULATION METHOD TO CHECK Click here

    B

  2. REPLACE HYBRID VEHICLE CONTROL ECU ASSEMBLY


    1. Replace the hybrid vehicle control ECU assembly with a new one.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  3. CHECK FOR DTCs


    1. Clear the DTCs.


      Powertrain > Radar Cruise > Clear DTCs

    2. Perform the following to make sure that the DTC detection conditions are met.

      Tech Tips

      If the following conditions are not met, the system cannot detect the malfunction.


      1. Turn the power switch on (IG).

      2. Wait for 20 seconds or more.

    3. Check for DTCs.


      Powertrain > Radar Cruise > Trouble Codes
      Result
      Result Proceed to
      DTC C1A52 is not output A
      DTC C1A52 is output B

    A

    END (HYBRID VEHICLE CONTROL ECU ASSEMBLY WAS DEFECTIVE)

    B

    REPLACE DRIVING SUPPORT ECU ASSEMBLY Click here