REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR ENGINE OIL SEAL


    1. Apply MP grease to the lip of a new rear engine oil seal.

      Note


      • Keep the lip free from foreign matter.

      • Do not allow MP grease to contact the dust seal.

    2. A01OB0OC03
      *a -0.2 to 0.9 mm (-0.00787 to 0.0354 in.)

      Using SST and a hammer, tap in the rear engine oil seal.

      SST
      09223-15030   ( 09951-07150 )
      Standard Depth
      -0.2 to 0.9 mm (-0.00787 to 0.0354 in.)

      Note


      • Do not tap in the rear engine oil seal at an angle.

      • Keep the lip free from foreign matter.

      • Wipe off any MP grease from the crankshaft.

  2. INSTALL FLYWHEEL SUB-ASSEMBLY


    1. A01OAZSN03

      Using SST, hold the crankshaft pulley assembly.

      SST
      09213-54015

      Tech Tips

      Part number of the installation bolt for SST (crankshaft pulley holding tool): 91551-80650 (quantity: 2)

    2. Clean the bolts and bolt holes.

    3. A01ODEIC91
      *a Adhesive

      Apply adhesive to 2 or 3 threads at the end of each of the 8 bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

      Note

      Install the bolts within 3 minutes of applying adhesive.

    4. A01OBB6N02

      Install the flywheel sub-assembly with the 8 bolts. Uniformly tighten the 8 bolts in the order shown in the illustration.

      Torque:
      130 N*m  { 1326 kgf*cm, 96 ft.*lbf }

      Note


      • Do not start the engine for at least 1 hour after installing the flywheel sub-assembly.

      • Make sure there is no foreign matter or oil on the flywheel sub-assembly.

  3. INSTALL TRANSMISSION INPUT DAMPER ASSEMBLY


    1. A01OAZSN03

      Using SST, hold the crankshaft pulley assembly.

      SST
      09213-54015

      Tech Tips

      Part number of the installation bolt for SST (crankshaft pulley holding tool): 91551-80650 (quantity: 2)

    2. A01OB2SC02
      B004EIV Engine Side

      Install the transmission input damper assembly with the 6 bolts. Uniformly tighten the 6 bolts in the order shown in the illustration.

      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Note


      • Make sure that there is no oil on the transmission input damper assembly or flywheel sub-assembly.

      • Make sure to install the transmission input damper assembly in the correct direction.

      • Do not allow grease to contact the splines of the transmission input damper assembly or the input shaft.

  4. INSTALL HYBRID VEHICLE TRANSMISSION ASSEMBLY

    Click here