ENGINE COOLANT TEMPERATURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR

    Tech Tips

    Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

    Click here


    1. Install a new gasket to the engine coolant temperature sensor.

    2. B004F3XC01
      *a 19 mm Ball Joint Lock Nut Wrench
      *b Torque Wrench Fulcrum Length

      Using a 19 mm ball joint lock nut wrench, install the engine coolant temperature sensor to the water outlet sub-assembly.

      Torque:
      Specified tightening torque
      19.6 N*m  { 200 kgf*cm, 14 ft.*lbf }

      Note

      If the engine coolant temperature sensor has been struck or dropped, replace it.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using a 19 mm ball joint lock nut wrench (fulcrum length of 150 mm (5.91 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)):

        10 N*m (102 kgf*cm, 7 ft.*lbf)

    3. Connect the engine coolant temperature sensor connector.

  2. CONNECT ENGINE WIRE


    1. Connect the engine wire with the 2 wire harness clamps.

  3. ADD ENGINE COOLANT (for Engine)

    Click here

  4. INSPECT FOR ENGINE COOLANT LEAK (for Engine)

    Click here

  5. INSTALL CENTER NO. 4 ENGINE UNDER COVER

    Click here

  6. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  7. PERFORM INITIALIZATION


    1. Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

      Click here