QUARTER WINDOW GLASS REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT DOOR SCUFF PLATE LH

    Click here

  2. REMOVE REAR SEAT CUSHION ASSEMBLY

    Click here

  3. REMOVE REAR SEAT CUSHION LOCK HOOK

    Click here

  4. REMOVE LAP BELT OUTER ANCHOR COVER

    Click here

  5. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH

    Click here

  6. DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH

    Click here

  7. REMOVE REAR SIDE SEATBACK ASSEMBLY LH

    Click here

  8. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH

    Click here

  9. REMOVE CENTER PILLAR GARNISH ASSEMBLY LH

    Click here

  10. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY LH

    Click here

  11. REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY LH

    Click here

  12. REMOVE ROOF SIDE RAIL WEATHERSTRIP LH

    Click here

  13. REMOVE QUARTER WINDOW ASSEMBLY


    1. w/ Glass Breakage Sensor:


      1. B004EVD

        Disconnect the connector.

      2. Disengage the clamp and disconnect the wire harness.

    2. w/ DAB Function:


      1. B004G7N

        Disconnect the connector.

    3. B004GG0C01
      B004FO9 Protective Tape

      Apply protective tape to the area around the installation position of the quarter window assembly on the vehicle body to prevent it from being scratched.

    4. B004F74C01
      *1 Clip
      *a Piano Wire

      Pass a piano wire between the vehicle body and quarter window assembly from the interior.

      Note

      Do not pull the piano wire in a vertical direction, but pull it in a horizontal direction.

    5. Tie both wire ends to wooden blocks or similar objects that can serve as handles.

    6. Cut off the adhesive by pulling the piano wire around the quarter window assembly.

      Note

      When separating the quarter window assembly, be careful not to damage the paint or interior and exterior ornaments.

    7. B004FDC

      Using suction cups, disengage the 3 clips and remove the quarter window assembly.

      Note


      • Be careful not to drop the quarter window assembly.

      • Be sure to replace the quarter window assembly with a new one.

  14. CLEAN VEHICLE BODY


    1. Clean and shape the contact surface of the vehicle body.


      1. B004G3IC01
        *a Vehicle Body
        B004FO9 Adhesive

        Using a knife, cut away excess adhesive on the contact surface of the vehicle body as shown in the illustration.

        Standard Dimension
        Area Dimension
        a 1.0 mm (0.0394 in.) or more

        Note

        Be careful not to damage the vehicle body.

        Tech Tips

        Leave approximately 1.0 mm (0.0394 in.) of adhesive on the vehicle body.

    2. Clean the contact surface of the vehicle body with a piece of cloth saturated with non-residue solvent.

      Tech Tips

      Even if all of the adhesive has been removed, clean the vehicle body.