WHEEL OPENING MOULDING(for Rear Side) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL QUARTER OUTSIDE MOULDING SUB-ASSEMBLY

    Tech Tips

    When installing a new quarter outside moulding sub-assembly, heat the vehicle body and quarter outside moulding sub-assembly using a heat light.

    Heating Temperature
    Item Temperature
    Vehicle Body 40 to 60°C (104 to 140°F)
    Quarter Outside Moulding Sub-assembly 20 to 30°C (68 to 86°F)

    Note

    Do not heat the vehicle body or quarter outside moulding sub-assembly excessively.


    1. Clean the vehicle body surface.


      1. Using a heat light, heat the vehicle body surface.

      2. Remove any double-sided tape from the vehicle body.

      3. Wipe off any tape adhesive residue with cleaner.

    2. Remove the release paper from a new quarter outside moulding sub-assembly.

      Tech Tips

      After removing the release paper, keep the exposed adhesive free from foreign matter.

    3. B005OP8C02
      *a Double-sided Tape
      B005OOA Install in this Direction

      Engage the 4 clips and attach the double-sided tape.

      Tech Tips

      Press the quarter outside moulding sub-assembly to install it.

    4. Engage the 4 claws.

    5. Using a 4 mm hexagon socket wrench, install the screw.

    6. Install the quarter outside moulding sub-assembly with the 2 clips.