WHEEL OPENING MOULDING(for Front Side) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. DISCONNECT FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY


    1. A01RAYK

      Remove the 2 clips and disconnect the front fender splash shield sub-assembly.

  2. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY


    1. A01RA2R

      Remove the 4 clips.

    2. A01RCO6C02
      B005OOA Remove in this Direction (1)
      B005OMH Remove in this Direction (2)

      Pull back the edge of the front fender splash shield sub-assembly and disengage the 5 claws by pushing the area indicated by the arrow in the illustration with a finger.

      Note


      • Do not apply excessive force when pulling back the front fender splash shield sub-assembly.

      • To avoid damaging the claws, do not forcibly pull the front fender moulding sub-assembly.

    3. Disengage the 9 clips as shown in the illustration to remove the front fender moulding sub-assembly.