WINDSHIELD OUTSIDE MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL NO. 3 WINDSHIELD OUTSIDE MOULDING CLIP

    Tech Tips

    Perform the following procedure only when replacement of a No. 3 windshield outside moulding clip is necessary.


    1. B005P41

      Using a riveter with a nose piece, install 5 new No. 3 windshield outside moulding clips.

      Tech Tips

      If the mandrel of the No. 3 windshield outside moulding clip does not come off on the first operation of the rivet gun, slide the rivet gun forward on the mandrel and operate it again.

      Note


      • Do not pry the No. 3 windshield outside moulding clip with the riveter, as this will cause damage to the riveter and mandrel.


      • B005OC4C01
        *a Riveter
        *b Incorrect

        Confirm that the No. 3 windshield outside moulding clips are seated properly against the vehicle body.


      • Do not tilt the riveter when installing the No. 3 windshield outside moulding clip to the vehicle body.

      B005OSWC01
      *a Riveter
      *b Mandrel
      *c Incorrect

    2. Install the windshield glass sub-assembly.

      Click here

  2. INSTALL NO. 1 WINDSHIELD OUTSIDE MOULDING CLIP

    Tech Tips

    Perform the following procedure only when replacement of a No. 1 windshield outside moulding clip is necessary.


    1. Engage the 5 claws as shown in the illustration to install 5 new No. 1 windshield outside moulding clips to the No. 3 windshield outside moulding clip.

      B005O0RC02
      B005OOA Install in this Direction - -

  3. INSTALL WINDSHIELD OUTSIDE MOULDING


    1. B005PJK

      Engage the 10 claws.

    2. B005MTEC01
      B005OOA Install in this Direction

      Engage the 2 clips as shown in the illustration to install the windshield outside moulding.