REAR DOOR BELT MOULDING INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL REAR DOOR BELT MOULDING ASSEMBLY

   
   

   1. 

      Install in this Direction

      Engage the 8 claws as shown in the illustration to install the rear door belt moulding assembly.

2. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

   Click here

3. INSTALL REAR DOOR REAR GUIDE SEAL

   Click here

4. CONNECT REAR DOOR WEATHERSTRIP

   Click here

5. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

   Click here

6. INSTALL REAR DOOR GLASS RUN

   Click here

7. INSTALL REAR DOOR SERVICE HOLE COVER

   Click here

8. INSTALL REAR DOOR NO. 2 TRIM BRACKET

   Click here

9. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

   Click here

10. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

11. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

12. INSTALL REAR DOOR ARMREST COVER

    Click here

13. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

    Click here

14. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

16. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

17. INSPECT POWER WINDOW OPERATION

    Click here