REAR BUMPER(w/o Rear No. 2 Seat) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear bumper removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear bumper assembly (w/ Intelligent clearance sonar system)

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

  • Intelligent clearance sonar system

  • LEXUS parking assist-sensor system

Click here

PROCEDURE


  1. REMOVE REAR LIGHT COVER LH

    Click here

  2. REMOVE REAR LIGHT COVER RH

    Tech Tips

    Use the same procedure as for the LH side.

  3. DISCONNECT QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH


    1. A01VUHPC02
      B005M97 Protective Tape

      Apply protective tape around the quarter outside moulding sub-assembly LH and rear bumper assembly as shown in the illustration.

    2. A01VUQB

      Using a 4 mm hexagon socket wrench, remove the screw.

    3. Remove the clip.

    4. A01VU8YC01
      B005OOA Remove in this Direction (1)
      B005OMH Remove in this Direction (2)

      Pull back the edge of the rear wheel house liner LH and disengage the 4 claws by pushing the area indicated by the arrow in the illustration with a finger.

      Note


      • Do not apply excessive force when pulling back the rear wheel house liner LH.

      • To avoid damaging the claws, do not forcibly pull the quarter outside moulding sub-assembly LH.

    5. Disengage the clip to disconnect the quarter outside moulding sub-assembly LH from the rear bumper assembly.

  4. DISCONNECT QUARTER OUTSIDE MOULDING SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  5. REMOVE REAR BUMPER ASSEMBLY


    1. A01VV1G

      Remove the 4 screws.

    2. A01VY1I

      Remove the 6 clips.

    3. A01VY33C01
      B005OOA Remove in this Direction

      Disengage the 5 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. A01VW60C01
      B005OOA Remove in this Direction

      Disengage the 2 claws as shown in the illustration to remove the rear bumper assembly.

    5. w/ LEXUS Parking Assist-sensor System:


      1. Disconnect the connector.