AHS ECU REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during AHS ECU removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly Front television camera view adjustment Panoramic view monitor system

Click here for Initialization

Click here for Calibration

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE HEADLIGHT ASSEMBLY

    Click here

  2. REMOVE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY

    Note

    Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.


    1. B005P8O

      Remove the 3 screws.

    2. B005N8F

      Remove the connector cover.

    3. B005MRY

      Disconnect the 2 connectors to remove the headlight light control ECU sub-assembly.

      Note

      If the headlight light control ECU sub-assembly has been struck or dropped, replace it with a new one.

  3. REMOVE HEADLIGHT GASKET

    Note

    Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.


    1. B005P03

      Remove the headlight gasket.