SIDE TURN SIGNAL LIGHT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during side turn signal light assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Side television camera assembly LH

  • Side television camera assembly RH

 Side television camera view adjustment Panoramic view monitor system

Click here for Initialization

Click here for Calibration

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE OUTER MIRROR

    Click here

  2. REMOVE NO. 1 OUTER MIRROR COVER

    Click here

  3. REMOVE NO. 2 OUTER MIRROR COVER

    Click here

  4. REMOVE OUTER MIRROR HOLE COVER

    Click here

  5. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY


    1. B005LMP

      Disconnect the connector.

    2. B005LSU

      Disengage the 2 claws to remove the side turn signal light assembly.