| DTC Code | DTC Name |
|---|---|
| B2414 | Steering Position Sensor Malfunction |
DESCRIPTION
The headlight ECU sub-assembly LH receives signals indicating direction and amount the steering wheel is turned from the steering sensor using CAN communication. The headlight ECU sub-assembly LH stores DTC B2414.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B2414 | Steering Position Sensor Malfunction | Malfunction in steering sensor |
|
- |
WIRING DIAGRAM
| *1 | Steering Sensor |
| *2 | Headlight ECU Sub-assembly LH |
| *3 | CAN Communication Line |
CAUTION / NOTICE / HINT
Note
Perform the communication function inspections in Diagnosis System to confirm that there are no CAN communication malfunctions before performing the following procedure.
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
PROCEDURE
CLEAR DTC
for Single Beam Headlight:
Clear the DTCs.
for Triple Beam Headlight:
Clear the DTCs.
| Result | ||
|---|---|---|
|
| NEXT |
|
CHECK FOR DTC
Turn the engine switch on (IG).
for Single Beam Headlight:
Check for DTCs.
| OK |
|---|
| DTC B2414 is not output. |
for Triple Beam Headlight:
Check for DTCs.
| OK |
|---|
| DTC B2414 is not output. |
| Result | |||
|---|---|---|---|
|
| OK |
|
USE SIMULATION METHOD TO CHECK Click here |
| NG |
|
REPLACE STEERING SENSOR
Replace the steering sensor with a new or known good one.
for Single Beam Headlight:
Check for DTCs.
| OK |
|---|
| DTC B2414 is not output. |
for Triple Beam Headlight:
Check for DTCs.
| OK |
|---|
| DTC B2414 is not output. |
| Result | |||
|---|---|---|---|
|
| OK |
|
END (STEERING SENSOR WAS DEFECTIVE) |
| NG |
|
REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH Click here |