RELAY ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT WIPER RELAY


    1. A01RBGAC29
      *a

      Component without harness connected

      (WIPER Relay)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
      Battery voltage applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the WIPER relay.

  2. INSPECT H-LP CLN RELAY


    1. A01R9L8C04
      *a

      Component without harness connected

      (H-LP CLN Relay)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
      Battery voltage applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the H-LP CLN relay.

  3. INSPECT WSH NZL HTR RELAY


    1. A01R9L8C04
      *a

      Component without harness connected

      (WSH NZL HTR Relay)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
      Battery voltage applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the WSH NZL HTR relay.