HEADLIGHT CLEANER MOTOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight cleaner motor and pump assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly Front television camera view adjustment Panoramic view monitor system

Click here for Initialization

Click here for Calibration
Front bumper assembly (w/ Intelligent clearance sonar system)

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

  • Intelligent clearance sonar system

  • LEXUS parking assist-sensor system

Click here

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  2. REMOVE HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY


    1. B005P3AC02
      B005OOA Remove in this Direction

      Loosen the clip and remove the headlight cleaner hose as shown in the illustration.

    2. B005NNMC02
      B005OOA Remove in this Direction

      Disconnect the connector.

    3. Remove the headlight cleaner motor and pump assembly as shown in the illustration.