HEADLIGHT CLEANER ACTUATOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight washer actuator sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly Front television camera view adjustment Panoramic view monitor system

Click here for Initialization

Click here for Calibration

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  2. REMOVE HEADLIGHT WASHER COVER LH

    Click here

  3. REMOVE HEADLIGHT WASHER COVER RH

    Tech Tips

    Use the same procedure as for the LH side.

  4. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH


    1. B005O2QC02
      B005NIZ Push
      B005OOA Disconnect in this Direction

      Disengage the claw and disconnect the No. 4 headlight cleaner hose as shown in the illustration.

    2. B005O6L

      Remove the screw.

    3. Disengage the claw and guide as indicated by the arrows, in the order shown in the illustration to remove the headlight washer actuator sub-assembly LH.

      B005MAWC02
      B005OOA Remove in this Direction (1) B005OMH Remove in this Direction (2)
      B005P54 Remove in this Direction (3) - -

  5. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.