FRONT WIPER RUBBER REPLACEMENT

CAUTION / NOTICE / HINT

Note

Make sure to hold the front wiper arm while lifting it as lifting the front wiper arm by the front wiper blade may damage or deform the front wiper blade.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT WIPER BLADE


    1. Turn the engine switch on (IG).

    2. Turn the engine switch off and operate and hold the windshield wiper switch assembly in the MIST position for 2 seconds or more.

      Tech Tips

      If the front wiper blade does not move to the service position, turn the engine switch on (IG) and then perform this procedure again.

    3. A01RECRC01
      *a Lock Button
      B005NIZ Push
      B005OOA Remove in this Direction

      Push the lock button of the front wiper blade to release the lock.

    4. Remove the front wiper blade from the front wiper arm as shown in the illustration.

      Note

      Place a piece of cloth between the front wiper arm and windshield glass to avoid damaging the windshield glass.

  2. REMOVE FRONT WIPER BLADE RUBBER


    1. A01R8OTC01
      B005OOA Remove in this Direction

      Disengage the claw and remove the front wiper blade rubber from the front wiper blade as shown in the illustration.

  3. INSTALL FRONT WIPER BLADE RUBBER


    1. Insert the front wiper blade rubber into the front wiper blade.

    2. A01REYRC01
      B005OOA Install in this Direction

      Engage the claw to install the front wiper blade rubber as shown in the illustration.

      Note

      Make sure the claw is securely engaged or the front wiper blade rubber may come out of the front wiper blade while driving or using the windshield wipers.

  4. INSTALL FRONT WIPER BLADE


    1. A01RF9OC01
      *a Lock Button
      B005OOA Install in this Direction

      Slide the front wiper blade until the lock button locks to install the front wiper blade.

      Note

      Make sure that the lock button locks so that it is installed securely.

    2. Turn the engine switch on (IG).

    3. Operate the windshield wiper switch assembly to return the front wiper arm and blade assemblies to their original position.

    4. Turn the engine switch off.