BACK DOOR CLOSER ECU REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during back door closer ECU removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Multiplex network door ECU Reset Back Door Close Position Power back door system

Click here

Note

When the multiplex network door ECU is replaced, the back door automatic open stop position (memory stopped position) must be registered. Make sure to make a note of the automatic open stop position.

PROCEDURE


  1. REMOVE BACK WINDOW UPPER PANEL TRIM

    Click here

  2. REMOVE BACK DOOR TRIM COVER LH

    Click here

  3. REMOVE BACK DOOR TRIM COVER RH

    Tech Tips

    Use the same procedure as for the LH side.

  4. REMOVE BACK DOOR LOCK COVER

    Click here

  5. REMOVE BACK DOOR TRIM BASE

    Click here

  6. REMOVE DOOR PULL HANDLE

    Click here

  7. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

    Click here

  8. REMOVE BACK DOOR TRIM PANEL ASSEMBLY

    Click here

  9. REMOVE MULTIPLEX NETWORK DOOR ECU


    1. B005P45

      Disconnect the 2 connectors.

    2. B005Q9T

      Remove the 2 bolts.

    3. Disengage the 2 guides to remove the multiplex network door ECU.