POWER SEAT SWITCH(for Rear Side) INSPECTION

PROCEDURE


  1. INSPECT REAR POWER SEAT SWITCH LH


    1. for LH Side:


      1. A01RFT4C04
        *a

        Component without harness connected

        (Rear Power Seat Switch LH)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        2 (FLDL) - 7 (E) FOLD switch pressed Below 100 Ω

        2 (FLDL) - 7 (E)

        3 (RTNL) - 7 (E)

        		 OFF 1 MΩ or higher
        3 (RTNL) - 7 (E) RETURN switch pressed Below 100 Ω

        If the result is not as specified, replace the rear power seat switch LH.

  2. INSPECT REAR POWER SEAT SWITCH RH


    1. for RH Side:


      1. A01RFT4C05
        *a

        Component without harness connected

        (Rear Power Seat Switch RH)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        2 (RTNR) - 7 (E) RETURN switch pressed Below 100 Ω

        2 (RTNR) - 7 (E)

        3 (FLDR) - 7 (E)

        		 OFF 1 MΩ or higher
        3 (FLDR) - 7 (E) FOLD switch pressed Below 100 Ω

        If the result is not as specified, replace the rear power seat switch RH.

  3. INSPECT FOLD SEAT SWITCH ASSEMBLY


    1. A01RBZJC01
      *a

      Component without harness connected

      (Fold Seat Switch Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (RTRN) - 7 (E) RETURN RH switch pressed Below 1 Ω
      6 (FOLD) - 7 (E) FOLD RH switch pressed

      1 (RTRN) - 7 (E)

      3 (RTRN) - 7 (E)

      6 (FOLD) - 7 (E)

      8 (FOLD) - 7 (E)

      		 OFF Below 1 Ω
      3 (RTRN) - 7 (E) RETURN LH switch pressed Below 1 Ω
      8 (FOLD) - 7 (E) FOLD LH switch pressed

      If the result is not as specified, replace the fold seat switch assembly.

    2. Apply battery voltage to the switch connector and check that the fold seat switch assembly illuminates.

      OK
      Condition Specified Condition

      Battery positive (+) → Terminal 5 (+B)

      Battery negative (-) → Terminal 4 (ILL-)

      		 Illumination illuminates

      If the result is not as specified, replace the fold seat switch assembly.