CENTER AIRBAG SENSOR ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL AIRBAG SENSOR ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      B005NWT
    3. B005OST

      Install the airbag sensor assembly with the 3 bolts.

      Torque:
      17.5 N*m  { 178 kgf*cm, 13 ft.*lbf }

      Note


      • If the airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the airbag sensor assembly, make sure that the SRS wiring does not interfere with or is not pinched between other parts.

      • When the engine switch is first turned on (IG) after the airbag sensor assembly has been replaced, make sure that no one is in the vehicle.

    4. B005L6JC01
      *a Waterproof Sheet

      Connect the connectors to the airbag sensor assembly as shown in the illustration.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    5. Check that the waterproof sheet is properly set.

    6. Check that there is no looseness in the installed parts of the airbag sensor assembly.

  2. INSTALL FRONT NO. 1 CONSOLE BOX INSERT

    Click here

  3. INSTALL FRONT NO. 2 CONSOLE BOX INSERT

    Click here

  4. INSTALL CONSOLE BOX ASSEMBLY

    Click here

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  6. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  7. INSPECT SRS WARNING LIGHT

    Click here

  8. PERFORM CALIBRATION


    1. When the airbag sensor assembly (center airbag sensor assembly) is replaced, perform calibration.

      for VSC System: Click here

      for Dynamic Torque Control AWD System: Click here

  9. PERFORM REGISTRATION (for Optitron Meter Type with Stop and Start System)


    1. When the airbag sensor assembly (center airbag sensor assembly) is replaced, perform registration.

      Click here