CENTER AIRBAG SENSOR ASSEMBLY ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

CAUTION:

Be sure to correctly follow the removal and installation procedures for the airbag sensor assembly.

PROCEDURE


  1. INSPECT AIRBAG SENSOR ASSEMBLY (for Vehicle not Involved in Collision)


    1. Perform a diagnostic system check.

      Click here

  2. INSPECT AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)


    1. Perform a diagnostic system check.

      Click here

    2. Visually check for defects with the airbag sensor assembly installed to the vehicle.

      Tech Tips

      The defects are as follows:


      • Cracks in the sensor housing

      • Dents in the sensor housing

      • Chips in the sensor housing

      • Cracks or other damage to the connectors

      • Peeling of the label

      OK
      No defects are found.

      If any defects are found, replace the airbag sensor assembly with a new one.

  3. INSPECT AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag is Deployed)


    1. Replace the airbag sensor assembly.

      Tech Tips

      The airbag sensor assembly should be replaced after any of the SRS parts has deployed, as it has been subjected to an impact.