TRIP SWITCH INSTALLATION

PROCEDURE

1. INSTALL TRIP SWITCH

   
   

   1. 

      Install in this Direction

      Engage the 2 claws as shown in the illustration to install the trip switch.

2. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

   Click here

3. INSTALL LOWER INSTRUMENT FINISH PANEL SUB

   Click here

4. INSTALL INSTRUMENT CLUSTER FINISH PANEL ORNAMENT

   Click here

5. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

   Click here

6. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

   Click here

7. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

   Click here

8. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

   Click here

9. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

10. INSTALL COWL SIDE TRIM BOARD

    Click here

11. INSTALL FRONT DOOR SCUFF PLATE

    Click here

12. INSTALL INSTRUMENT PANEL GARNISH

    Click here

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

14. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

    Click here