AMBIENT LIGHT(for Rear Door) INSPECTION

PROCEDURE


  1. INSPECT REAR DOOR TRIM BOARD SUB-ASSEMBLY LH (REAR DOOR AMBIENT ILLUMINATION LIGHT LH)


    1. A01R963C04
      *a

      Component without harness connected

      (Rear Door Trim Board Sub-assembly LH)

      Apply battery voltage to the connector and check that the rear door ambient illumination light LH comes on.

      OK
      Measurement Condition Condition Specified Condition

      Battery positive (+) → 1 (+)

      Battery negative (-) → 2 (-)

      		 Always Rear door ambient illumination light LH comes on

      If the result is not as specified, replace the rear door trim board sub-assembly LH.

  2. INSPECT REAR DOOR TRIM BOARD SUB-ASSEMBLY RH (REAR DOOR AMBIENT ILLUMINATION LIGHT RH)


    1. A01R963C04
      *a

      Component without harness connected

      (Rear Door Trim Board Sub-assembly RH)

      Apply battery voltage to the connector and check that the rear door ambient illumination light RH comes on.

      OK
      Measurement Condition Condition Specified Condition

      Battery positive (+) → 1 (+)

      Battery negative (-) → 2 (-)

      		 Always Rear door ambient illumination light RH comes on

      If the result is not as specified, replace the rear door trim board sub-assembly RH.