REAR DOOR ADJUSTMENT

CAUTION / NOTICE / HINT

A01RBYRC01
*a Centering Bolt
*b Standard Bolt

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

  • Centering bolts are used to install the door hinges to the vehicle body and door. The door cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.

  • The specified torque for standard bolts is shown in the standard bolt chart.

    Click here

PROCEDURE


  1. INSPECT REAR DOOR


    1. Check that the clearance measurements of areas a through j are within each standard range.

      A01RELUN01
      Standard Clearance
      Area Measurement Area Measurement
      a -2.0 to 2.0 mm (-0.0787 to 0.0787 in.) b 2.1 to 6.1 mm (0.0827 to 0.240 in.)
      c 3.5 to 6.5 mm (0.138 to 0.256 in.) d -0.5 to 2.5 mm (-0.0197 to 0.0984 in.)
      e 4.7 to 7.7 mm (0.185 to 0.303 in.) f -1.5 to 1.5 mm (-0.0591 to 0.0591 in.)
      g 2.0 to 5.0 mm (0.0787 to 0.197 in.) h -1.5 to 1.5 mm (-0.0591 to 0.0591 in.)
      i -1.2 to 1.2 mm (-0.0472 to 0.0472 in.) j 2.3 to 4.7 mm (0.0906 to 0.185 in.)

  2. ADJUST REAR DOOR

    Note

    Make sure to turn the ignition switch off when adjusting door lock strikers.


    1. A01R9H1

      Using SST, loosen the 4 hinge bolts on the vehicle body and adjust the door position.

      SST
      09812-00020

    2. Tighten the 4 hinge bolts on the vehicle body after adjustment.

      Torque:
      32.5 N*m  { 331 kgf*cm, 24 ft.*lbf }

    3. Loosen the 4 hinge bolts on the door and adjust the door position.

    4. Tighten the 4 hinge bolts on the door after adjustment.

      Torque:
      32.5 N*m  { 331 kgf*cm, 24 ft.*lbf }
    5. A01RCI4

      Disengage the 4 claws to remove the rear door lock striker cover.

    6. A01RFR7

      Using a T40 "TORX" socket wrench, slightly loosen the 2 striker mounting screws.

    7. Using a brass bar and a hammer, hit the striker to adjust its position.

    8. Using a T40 "TORX" socket wrench, tighten the 2 striker mounting screws after adjustment.

      Torque:
      23 N*m  { 235 kgf*cm, 17 ft.*lbf }
    9. A01RCI4

      Engage the 4 claws to install the rear door lock striker cover.