POWER BACK DOOR CONTROL SWITCH INSPECTION

PROCEDURE


  1. INSPECT POWER BACK DOOR SWITCH (INTEGRATION CONTROL AND PANEL ASSEMBLY)


    1. Check the operation of the power back door switch (integration control and panel assembly).


      1. A01RBCQC03
        *a

        Component without harness connected

        (Power Back Door Switch (Integration Control and Panel Assembly))

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        4 - 14 Power back door switch (integration control and panel assembly) not pushed 1 MΩ or higher
        4 - 14 Power back door switch (integration control and panel assembly) pushed Below 100 Ω

        If the result is not as specified, replace the power back door switch (integration control and panel assembly).

    2. Check that the switch illuminates.


      1. Apply battery voltage to the power back door switch (integration control and panel assembly) and check that the LED illuminates.

        OK
        Battery Connection Specified Condition

        Battery positive (+) → 7

        Battery negative (-) → 12

        		 LED illuminates

        If the result is not as specified, replace the power back door switch (integration control and panel assembly).