ELECTRICAL KEY OSCILLATOR(for Outside Luggage Compartment) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during electrical key removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear bumper assembly (w/ Intelligent clearance sonar system)

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

 Intelligent clearance sonar system

Click here

PROCEDURE


  1. REMOVE REAR BUMPER ASSEMBLY (w/o Rear No. 2 Seat)

    Click here

  2. REMOVE REAR BUMPER ASSEMBLY (w/ Rear No. 2 Seat)

    Click here

  3. REMOVE REAR BUMPER ENERGY ABSORBER (w/o Rear No. 2 Seat)

    for Type A:

    Click here

    for Type B:

    Click here

  4. REMOVE REAR BUMPER ENERGY ABSORBER (w/ Rear No. 2 Seat)

    Click here

  5. REMOVE ELECTRICAL KEY ANTENNA


    1. B005NVEC02
      B005OOA Remove in this Direction

      Disconnect the connector.

    2. Remove the nut.

    3. Disengage the guide to remove the electrical key antenna as shown in the illustration.

      Note

      Be careful when removing the electrical key antenna. If the electrical key antenna is dropped, replace it with a new one.