ENTRY AND START SYSTEM(for Entry Function) Entry Lock Function does not Operate Using Close & Lock Function

DESCRIPTION

If the back door does not lock when using the power back door close and lock function, there may be communication problem between the certification ECU (smart key ECU assembly) and main body ECU (multiplex network body ECU).

CAUTION / NOTICE / HINT

Note


  • The entry and start system (for Entry Function) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the entry and start system (for Entry Function) after confirming that the communication systems are functioning properly.

    Click here

  • When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

  • After repair, confirm that no DTCs are output.

  • Check that there are no electrical key transmitter sub-assemblies in the vehicle.

  • Make sure that the electrical key transmitter sub-assembly is within the power back door close and lock function operating range when performing a back door close and lock operation.

    Click here

PROCEDURE


  1. CHECK FOR DTC


    1. Check for DTCs.


      Body Electrical > Entry&Start > Trouble Codes
      Result
      Result Proceed to
      DTCs are not output A
      DTCs are output B

    B

    GO TO DIAGNOSTIC TROUBLE CODE CHART Click here

    A

  2. CHECK FOR DTC


    1. Check for DTCs.


      Body Electrical > Back Door > Trouble Codes
      Result
      Result Proceed to
      DTCs are not output A
      DTCs are output B

    B

    GO TO POWER BACK DOOR SYSTEM Click here

    A

  3. CHECK POWER BACK DOOR CLOSE AND LOCK OPERATION


    1. Open the back door with the electrical key transmitter sub-assembly outside of the vehicle.

    2. B005PBMC01
      *1 Back Door Control Switch

      While carrying the electrical key transmitter sub-assembly, press the back door control switch twice and check that the back door closes automatically and then locks.

      Tech Tips

      If the power back door control switch is pressed by a hand which is also holding the electrical key transmitter sub-assembly, the electrical key transmitter sub-assembly may not be detected as in the exterior detection area and the power back door close and lock function may not operate.

      Result
      Result Proceed to
      Power back door close and lock function operates normally A
      Power back door close and lock function does not operate normally B

    A

    USE SIMULATION METHOD TO CHECK Click here

    B

    GO TO OTHER PROBLEM Click here