BLIND SPOT MONITOR SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during blind spot monitor sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of blind spot monitor sensor (w/o Intelligent clearance sonar system) Blind spot monitor beam axis inspection Blind Spot Monitor System

Click here

Replacement of blind spot monitor sensor (w/ Intelligent clearance sonar system) Blind spot monitor beam axis inspection

  • Blind Spot Monitor System

  • Intelligent clearance sonar system
Rear bumper assembly (w/ Intelligent clearance sonar system)

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

  • Intelligent clearance sonar system

  • LEXUS parking assist-sensor system (w/ Intelligent clearance sonar system)

Click here

PROCEDURE


  1. REMOVE REAR BUMPER ASSEMBLY

    Click here

  2. REMOVE BLIND SPOT MONITOR SENSOR LH


    1. B005PVX

      Disconnect the connector.

    2. Remove the 3 nuts and blind spot monitor sensor LH.

      Note

      Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact.

  3. REMOVE BLIND SPOT MONITOR SENSOR RH


    1. B005OL3

      Disconnect the connector.

    2. Remove the 3 nuts and blind spot monitor sensor RH.

      Note

      Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact.